304 STAINLESS · ADHESIVE MOUNT · OEM & AFTERMARKET

Chrome that outlasts the car.

Precision-rolled 304 stainless window trim with 3M adhesive backing. No drilling, no clips, no lifting edges — 20 minutes to fit, and the mirror finish still reads new after years of sun, rain and car washes.

MOQ 50 sets · 12-hour reply · 7-day production · 3200+ models covered

Request the spec sheet (PDF)

Free 10 cm sample strip for qualified buyers — ask in the quote.

Brushed stainless steel window trim fitted along the upper edge of a car's side window
Fitted on a 2023 mid-size sedan — factory rubber left untouched.
MATERIAL304 stainless steel
THICKNESS0.6 mm
ADHESIVE3M VHB tape
FINISHMirror / Brushed

02INSTALLATION

Twenty minutes, no drilling.

The strip is a cover, not a replacement — it bonds over the factory rubber, so the door seal stays intact, glass clearance is unchanged, and nothing gets drilled.

  1. 01

    Clean the frame

    Wipe the rubber and the paint line with IPA. The tape bonds to a dry, wax-free surface — nothing else.

  2. 02

    Dry-fit before peeling

    Set the strip in place, check the reveal gap front to back, and mark both ends with masking tape.

  3. 03

    Warm the tape line

    40–50 °C with a heat gun. Warm adhesive wets out faster and roughly doubles initial tack.

  4. 04

    Press and hold 60 seconds

    Firm pressure from the centre out. No washing and no highway speed for the first 24 hours.

Reverse side of a stainless trim strip showing the grey 3M adhesive tape and peeled release liner
3M VHB tape, 12 mm wide, continuous along the full length.
WhatsApp Get a quote